Which Cisco IOS command would prompt for input in the following format?

Which Cisco IOS command would prompt for input in the following format? A. ping 10.1.1.1 B. ping C. traceroute D. tracert Explanation:The extended ping command prompts the user for input in the format given in this scenario. The extended pingcommand is accessed by issuing a ping command without specifying an IP address. This causes the […]

Read More

What command produced the following output?

What command produced the following output? A. show ip process B. show ip route C. show ip protocols D. show ip routing process Explanation:The show ip protocols command is used to view the current state of active routing protocols. This command isissued from Privileged EXEC mode. It has the following syntax:Router# show ip protocolsThis command […]

Read More

Click and drag the components on the left to their appropriate descriptions on the right.

DRAG DROPClick and drag the components on the left to their appropriate descriptions on the right.Select and Place: Answer: Explanation:The following are the components used for network and Internet communications and their appropriatedescriptions:Router: Separates broadcast domains while connecting different networks. Routers provide a medium forconnecting Local Area Network (LAN) and Wide Area Networks (WAN) segmentsHub: […]

Read More

What can be the problem?

You have discovered that Router 8 on your network is not receiving updates from Router 10. Router10 has anIP address of 201.56.41.9. All routers run RIP. Since you are new and not completely familiar with the topologyof the network, you execute the debug ip rip command on Router 8 and receive the results shown below:Router8# […]

Read More

What part(s) of this submission are incorrect?

You are considering a candidate for a job as a Cisco network technician. As part of the assessment process,you ask the candidate to write down the commands required to configure a serial interface, in the proper orderwith the correct command prompts. The candidate submits the set of commands shown below (line numbersare for reference only):1 […]

Read More

Which switches should you designate as the root bridges?

You are the switch administrator for InterConn. The network is physically wired as shown in the diagram. Youare planning the configuration of STP. The majority of network traffic runs between the hosts and servers withineach VLAN. You would like to designate the root bridges for VLANS 10 and 20. Which switches should you designate as […]

Read More

Which Cisco switch feature should you use to achieve the objective?

You are a network administrator for your organization. Your organization has two Virtual LANs (VLANs) namedMarketing and Production. All switches in the network have both VLANs configured on them. Switches A, C, F,and G have user machines connected for both VLANs, while switches B, D, and E have user machinesconnected for the Production VLAN only. […]

Read More