Which of the following are you least likely to allocate?

View the Exhibit. You are designing an IP addressing scheme for the network in the exhibit above. Each switch represents hosts that reside in separate VLANs. The subnets should be allocated to match the following host capacities: Router subnet: two hosts SwitchA subnet: four hosts SwitchB subnet: 10 hosts SwitchC subnet: 20 hosts SwitchD subnet: […]

Read More

Packets sent to which of the following destination IP addresses will be forwarded to the 10.1.1.3

You issue the following commands on RouterA: Packets sent to which of the following destination IP addresses will be forwarded to the 10.1.1.3 next-hop IP address? (Choose two.) A. 172.16.0.1 B. 192.168.0.1 C. 192.168.0.14 D. 192.168.0.17 E. 192.168.0.26 F. 192.168.1.1 Section: Addressing and Routing Protocols in an Existing Network Explanation Explanation: Of the choices available, […]

Read More

Which of the following should not be implemented in the core layer?

Which of the following should not be implemented in the core layer? (Choose two.) A. ACLs B. QoS C. load balancing D. interVLAN routing E. a partially meshed topology Section: Enterprise Network Design Explanation Explanation: Access control lists (ACLs) and inter-VLAN routing should not be implemented in the core layer. Because the core layer focuses […]

Read More

Which of the following is most likely true?

You issue the show ip bgp neighbors command on RouterA and receive the following output: Which of the following is most likely true? A. RouterA is operating in AS 64496. B. RouterA has been assigned a BGP RID of 1.1.1.2. C. RouterA has been unable to establish a BGP session with the remote router. D. […]

Read More

Which of the following are you most likely to do?

View the Exhibit. Refer to the exhibit above. PVST+ is enabled on all the switches. The Layer 3 switch on the right, DSW2, is the root bridge for VLAN 20. The Layer 3 switch on the left, DSW1, is the root bridge for VLAN 10. Devices on VLAN 10 use DSW1 as a default gateway. […]

Read More

Which of the following VPN tunnels support encapsulation of dynamic routing protocol traffic?

Which of the following VPN tunnels support encapsulation of dynamic routing protocol traffic? (Choose three.) A. IPSec B. IPSec VTI C. GRE over IPSec D. DMVPN hub-and-spoke E. DMVPN spoke-to-spoke Explanation:Section: Enterprise Network Design ExplanationExplanation/Reference:IP Security (IPSec) Virtual Tunnel Interface (VTI), Generic Routing Encapsulation (GRE) over IPSec, and Dynamic Multipoint Virtual Private Network (DMVPN)hub-and-spoke virtual […]

Read More

Which of the following addresses is an outside local address?

HostA is a computer on your company’s network. RouterA is a NAT router. HostA sends a packet to HostB, and HostB sends a packet back to HostA. Which of the following addresses is an outside local address? A. 15.16.17.18 B. 22.23.24.25 C. 192.168.1.22 D. 192.168.1.30 Section: Addressing and Routing Protocols in an Existing Network Explanation […]

Read More

Which of the following OSPF areas accept all LSAs?

Which of the following OSPF areas accept all LSAs? (Choose two.) A. stub B. not-so-stubby C. totally stubby D. backbone E. standard Section: Addressing and Routing Protocols in an Existing Network Explanation Explanation:Standard areas and backbone areas accept all link-state advertisements (LSAs). Every router in a standard area contains the same Open Shortest Path First(OSPF) […]

Read More