Prev Question
Next Question

Examine the diagram below:

Based on the diagram and the following partial output from Router R2, which networks will be 1

Based on the diagram and the following partial output from Router R2, which networks will be present in the
routing table of Router R1?

Based on the diagram and the following partial output from Router R2, which networks will be 2

A. 192.168.5.0

B. 10.0.0.0

C. 172.50.0.0

D. 192.168.5.0 and 10.0.0.0

Explanation:
The routes that will be present in Router R1 are 192.168.5.0 and 10.0.0.0. According to the output, only the
route from EIGRP 55 will be redistributed to EIGRP 200. Therefore, the 10.0.0.0 network will be advertised
to Router R1 from Router R2 and the 192.168.5.0 network, which is present in the routing table of Router
R2, will be advertised to Router R1.
The 192.168.5.0 network alone would not be correct. The 10.0.0.0 network will be present as well.
The 172.50.0.0 network will not be present because Router 2 is not configured with a redistribution
statement for that network. The required statement would be redistribute ospf 1.
Objective:
Layer 3 Technologies
Sub-Objective:
Configure and verify redistribution between any routing protocols or routing sources
References:
Cisco > Home > Support > Technology Support > IP > IP Version 6 > Configure > Configuration Examples
and Technotes > Redistributing Routing Protocols

Prev Question
Next Question

Leave a Reply

Your email address will not be published. Required fields are marked *