Prev Question
Next Question

Which command sets the OSPF priority value of a router interface to 10?

A. Router(config)# ospf priority 10

B. Router(config-if)# ospf priority 10

C. Router(config)# ip ospf priority 10

D. Router(config-if)# ip ospf priority 10

Explanation:
The correct syntax for the ip ospf priority command is shown below:
Router(config-if)# ip ospf priority {number}
The number is a value from 0 to 255, and 1 is the default priority. A priority value of 0 means that the
interface cannot be elected as the designated router (DR) or backup designated router (BDR). The higher
the priority, the more preferred the router is when there is an election for DR and BDR for that network.
NOTE: The ip ospf priority command is entered in interface configuration mode, not router configuration
mode.
All other options either use incorrect syntax or are executed at an incorrect prompt.
Objective:
Layer 3 Technologies
Sub-Objective:
Configure and verify network types, area types, and router types
References:
Cisco IOS Master Command List, Release 12.4 > i through k > ip ospf priority

Prev Question
Next Question

Leave a Reply

Your email address will not be published. Required fields are marked *