With this configuration, which of the following is true?

Examine the configuration shown below in a partial output of the show run command executed from Router 5. With this configuration, which of the following is true? A. if POS 1/0 goes down, Router 5 will become the AVG. B. if POS 1/0 goes down, Router 5 will relinquish its role as AVG. C. if POS […]

Read More

Which of the following statements is TRUE about the reasons for the suggested change in the

You need to create an implementation plan for providing Layer 3 redundancy in your switched network. Youincluded Hot Standby Routing Protocol (HSRP) as the protocol to avoid first-hop router failure. However,your supervisor suggests including Virtual Router Redundancy Protocol (VRRP) instead of HSRP in theimplementation plan. Which of the following statements is TRUE about the reasons […]

Read More

How is load balancing achieved when implementing HSRP?

How is load balancing achieved when implementing HSRP? A. By configuring multiple gateways on the routers B. By using multiple HSRP groups C. By configuring the same priority on all HSRP group members D. By configuring multiple virtual router addresses Explanation: When implementing Hot Standby Router Protocol (HSRP), load balancing is achieved by using multipleHSRP […]

Read More

Which routers comprise a VRRP group?

Which routers comprise a VRRP group? A. Host and client B. Master and backup C. Active and standby D. Primary and secondary Explanation: Virtual Router Redundancy Protocol (VRRP) enables a group of routers to form a single virtual router,known as a VRRP group. Routers are configured in VRRP groups to provide redundancy for a virtual […]

Read More

Which virtual router states are defined in the GLBP protocol?

Which virtual router states are defined in the GLBP protocol? (Choose two.) A. Backup gateway B. Primary gateway C. Active virtual gateway D. Active secondary gateway E. Active virtual forwarder Explanation: Active virtual gateway and active virtual forwarder are the two states defined in the Gateway Load Balancing Protocol (GLBP). The active virtual gateway (AVG) […]

Read More

What does this output mean?

You are in the process of verifying the operation of your core switches, which are using HSRP. One core switch was left with the default priority; the other was given a lower priority to make it the standby switch. The command show standby brief was executed on one of the switches. Output of the command […]

Read More

Which command would NOT be useful for discovering the problem?

You are troubleshooting a problem with two routers configured in a HSRP group. You intended to configure the routers so that Router A and Router B would each track their respective Fa0/1 interfaces and decrement their priorities for several VLAN groups if the tracked interface went down. However, you find that Router A is not […]

Read More