What are two possible sources of the issue?

An engineer is troubleshooting a blade server in an FX2s. The compute sled in SLOT 3 will NOT power on.The engineer has taken the server down to minimum to POST. The server still does NOT power on. Theengineer then swaps sleds SLOT 2 and 3. The iDRAC initializes in SLOT 2 but SLOT 3 is […]

Read More

What should the engineer do to finish disbanding the chassis group?

A customer has five VRTXs in a chassis group that they need to disband. The engineer disbands thechassis group from the group leader, but a networking interruption prevents two of the VRTXs from gettingthe signal to leave the group. What should the engineer do to finish disbanding the chassis group? A. Remove the remaining members […]

Read More

Which policy should the engineer choose?

An engineer has a new blade chassis that is ѕ full. The chassis has six power supplies. The chassis atpeak power usage needs at minimum four power supplies. Redundancy is NOT a concern.The engineer needs a policy to meet the current needs and provide enough power to a fully populatedchassis. Which policy should the engineer […]

Read More

What is the cause?

An engineer is running an inventory report on a VRTX chassis group for a customer. When the engineerviews the report, the engineer notices the inventory of one of the VRTX is missing one of its nodes. What is the cause? A. The VRTX group member is in Chassis Power State Off since the node was […]

Read More

What is the most efficient method to perform this task?

An engineer has been given a new chassis and needs to configure the iDRACs on all servers prior todeploying an OS on them. The iDRACs need to be configured with IP addresses and a new root password. What is the most efficient method to perform this task? A. Use CMC QuickDeploy B. Use iDRAC QuickLaunch […]

Read More

Which CMC feature should an engineer use to perform this task?

An engineer needs to replicate BIOS and NIC settings for server nodes installed in the chassis. Which CMC feature should an engineer use to perform this task? A. AutoConfiguration B. Chassis Profiles C. QuickDeploy D. Server Profiles Explanation: Reference: http://www.dell.com/support/Manuals/us/en/19/dell-cmc-v1.10-fx2/CMC_FX2_FX2s_1.1_UserGuide-v1/Overview?guid=GUID-3A3CA051-1EAF-4F4E-9B34-47500ACAAAB4&lang=en-us Show Answer

Read More

What should be done to restore administrative access to the CMC?

A password to the CMC root account on an M1000e server chassis has been misplaced. What should be done to restore administrative access to the CMC? A. Reset root password using the PASSWORD_RSET jumper B. Issue password reset from a connected blade’s iDRAC C. Call Dell tech support and ask to reset CMC password via […]

Read More